Vandy Vape Berserker MTL RDA

The Vandy Vape Berserker Mini MTL RDA, is a mouth to lung RDA (Rebuildable Dripping Atomiser) that has a unique aesthetic and a level of customisability that is unseen in most rebuildables. Featuring Stainless Steel construction, an 18mm diameter and single coil build capabilities, this RDA is advised for advanced users only.

With an 18mm diameter, the Berserker is smaller than most standard RDAs, this is intentional as a smaller diameter equals a smaller chamber, giving the user a consistent mouth to lung draw along with increased flavour. For those worried about aesthetics, each kit comes with a 22mm and 24mm Beauty Ring allowing the RDA to sit flush on most vape mods.

The Berserker MTL RDA features a clamp deck, designed for a single rebuildable coil. This build deck allows your coil to be mounted easily despite the size, there’s also a specially designed correction tool included which allows the user to secure the coil while tightening the clamps.

What sets the Berserker apart from similar MTL RDAs is its airflow capabilities; as well as a standard adjustable airflow, there are also six airflow adaptors, each can slot into place under the build deck and allow complete customisation of your inhale for a tighter or looser draw.

The Heat Sink Drip Tip, combined with a drip shield and Ultem mouthpiece allows for a cooler vape without sacrificing on flavour. If that wasn’t enough, there is an extra BF (Bottom Feeding) Pin included with the kit, allowing you to transform the Berserker into a Squonk RDA.

Contains:

• 1 x Vandy Vape Berserker MTL RDA
• 1 x 22mm Beauty Ring
• 1 x 24mm Beauty Ring
• 1 x Coil Correction Tool
• 1 x BF (Bottom Feeding) Pin
• 6 x Airflow Adaptors
• 1 x User Manual

Features:

• 18mm Diameter
• Squonk Compatible
• Single Coil Build
• Dual Post Clamp Deck
• Mouth To Lung Inhale
• Unique Adjustable Airflow

Important information regarding Rebuildable Dripping Atomisers:

Rebuildable atomisers are recommended only for experienced users. You should have the knowledge and access to the equipment that is required to set up this atomiser properly.

Before building or using an RDA you should have a thorough knowledge of battery safety, Ohm’s Law and vaping in general.

Before fitting a coil onto your rebuildable atomiser ensure it is in a safe condition and registering the correct Ohmage, this testing and checking can be achieved by using a dedicated Ohmmeter. Coils should not be tested on vape devices.